Error code | Fault Code Description | Possible cause | Note |
P0741 | Torque Converter Clutch Solenoid Performance (Shift Solenoid Valve SL) | 1. Valve body (Shift solenoid SL) 2. Torque converter 3. Transmission fluid | |
P075B | Shift Solenoid G Performance or Stuck Off | 1. Valve body (Shift solenoid SC) 2. Torque converter 3. Transmission fluid | |
P2757 | Torque Converter Clutch Pressure Control Solenoid Performance (Shift Solenoid Valve SLU) | 1. Valve body (Shift solenoid SLU) 2. Torque converter 3. Transmission fluid | |
P2767 | Input / Turbine Speed Sensor B Circuit No Signal | 1. Transmission wire harness or its connector 2. Transmission speed sensor (NIN) 3. ECM | Standard resistance for NIN is 560 – 680 ohms at 20 degrees celsius (inconclusive test) |
P1586 | Acceleration Sensor Malfunction | 1. ECU ( Acceleration Sensor) 2. CAN system 3. Brake controller | |
P0712 | Transmission Fluid Temperature Sensor A Circuit Low Input | 1. Transmission wire harness or its connector 2. Transmission wire harness (CVT oil temperature sensor) 3. ECM | Pin 1 (THO) and Pin 7 (E2): 79 ohms to 156 Kohm |
P0713 | Transmission Fluid Temperature Sensor A Circuit High Input | 1. Transmission wire harness or its connector 2. Transmission wire harness (CVT oil temperature sensor) 3. ECM | Pin 1 (THO) and Pin 7 (E2): 79 ohms to 156 Kohm |
P0842 | Transmission Fluid Pressure Sensor/Switch A Circuit Low | 1. Transmission wire harness or its connector 2. Oil pressure sensor 3. ECM | |
P0843 | Transmission Fluid Pressure Sensor/Switch A Circuit High | 1. Transmission wire harness or its connector 2. Oil pressure sensor 3. ECM | |
P0720 | Output speed sensor circuit | 1. Transmission wire harness or its connector 2. Transmission speed sensor (NOUT) 3. ECM | |
P0722 | Output speed sensor circuit no signal | 1. Transmission wire harness or its connector 2. Transmission speed sensor (NOUT) 3. ECM | |
P0715 | Input/turbine speed sensor “A” circuit | 1. Transmission wire harness or its connector 2. Transmission speed sensor (NT) 3. ECM | |
P0717 | Input/turbine speed sensor “A” circuit no signal | 1. Transmission wire harness or its connector 2. Transmission speed sensor (NT) 3. ECM | |
P1585 | Acceleration sensor circuit | 1. ECU ( Acceleration Sensor) 2. CAN system 3. Brake controller | |
P099B | Shift solenoid “G” control circuit low (shift solenoid valve SC) | 1. Transmission wire harness or its connector 2. Transmission Valve body (Shift solenoid SC) 3. ECM | |
P099C | Shift Solenoid “G” control circuit high (shift solenoid valve SC) | 1. Transmission wire harness or its connector 2. Transmission Valve body (Shift solenoid SC) 3. ECM | |
P2820 | Pressure control solenoid “J” performance or stuck off | 1. CVT Transmission final drive (Solenoid SLP) | |
P0841 | Transmission fluid pressure sensor “A” performance | 1. Transmission Valve Body (Shift solenoid SLS) 2. Oil pressure sensor 3. ECM 4. Final drive | |
P2769 | Short in torque converter clutch solenoid circuit (shift solenoid valve SL) | 1. Transmission wire harness or its connector 2. Transmission Valve body (Shift solenoid SL) 3. ECM | |
P2770 | Open in torque converter clutch solenoid circuit (shift solenoid valve SL) | 1. Transmission wire harness or its connector 2. Transmission Valve body (Shift solenoid SL) 3. ECM | Pin 3 (SL) with respect to ground: 11 – 15 ohms |
P2822 | Pressure control solenoid “J” electrical (shift solenoid valve SLP) | 1. Transmission wire harness or its connector 2. Transmission Valve body (Shift solenoid SLP) 3. ECM | Pin 4 (SLP+) and pin 11(SLP-) 5 – 5.6 ohms at 20 degrees celsius |
P1589 | Acceleration sensor learning value | 1. Acceleration sensor learning not yet completed 2. Abnormal values observed during acceleration sensor learning process (ECU acceleration sensor) | Perform deceleration sensor zero point calibration |
P0711 | Transmission fluid temperature sensor “A” circuit range/performance | 1. Transmission oil level 2. Transmission wire harness (CVT oil temperature sensor) | |
P282B | Pressure control solenoid “K” electrical (shift solenoid valve SLS) | 1. Transmission wire harness or its connector 2. Transmission Valve body (Shift solenoid SLS) 3. ECM | Pin 5 (SLS+) and pin 12 (SLS-): 5 – 5.6 ohms at 20 degrees celsius |